Stump Remover 250g stump removal

Stump Remover

A product for accelerating stump decomposition and easier mechanical removal, applied into drilled holes.

Dosage and Use of Stump Remover

Drill a hole approximately 2 cm in diameter and approximately 20 cm deep into the centre of the stump. Drill another hole of the same size diagonally from the side, about 8 cm below the stump edge, so that both holes connect. This method can be used to remove stumps up to 30 cm in diameter. For larger diameters, the number of holes must be increased proportionally.

Pour approximately 100 g of the stump remover product into each hole combination and add warm water, which should then be topped up as needed over a period of 4-6 weeks. During this time, protect the cut surface of the stump from excessive rain. Saturating the stump with the product will allow rapid decomposition and facilitate its mechanical removal.